Building A Ride: Difference between revisions
Content added Content deleted
| Line 28: | Line 28: | ||
*At least one piece of connected Station Platform track (one station platform can fit the entrance on one side, and the exit on the other). |
*At least one piece of connected Station Platform track (one station platform can fit the entrance on one side, and the exit on the other). |
||
*Ride track that begins at the station platform's start and reconnects to the station platform's rear in a continuous loop (not neccesary if the operating mode is [[ |
*Ride track that begins at the station platform's start and reconnects to the station platform's rear in a continuous loop (not neccesary if the operating mode is [[Powered Launch]] or Reverse-Incline Circuit Mode, but make sure the train eventually reaches the station platform again in reverse). |
||
*Medium incline track with pull chains (not needed with powered launch mode). In reverse inclined shuttle launches, put the pull chains behind the station platform. Steep chain lifts are possible. |
*Medium incline track with pull chains (not needed with powered launch mode). In reverse inclined shuttle launches, put the pull chains behind the station platform. Steep chain lifts are possible. |
||
*Initial slope downwards after the pull chain ends, to build speed and allows the cars to finish the circuit. Make sure the highest non-lifthill peak is lower than the lift hill peak. |
*Initial slope downwards after the pull chain ends, to build speed and allows the cars to finish the circuit. Make sure the highest non-lifthill peak is lower than the lift hill peak. |
||