A message in the RCT2 manual saying that the dinghy slide does not include water.A good water slide requires at least one steep drop, but can be extended into a complex layout, so long as care is taken on the crests of hills, as dinghies can crash off the track.
A remedy for the problem is to build a completely circular section of track at the crests of hills and in the turns, which prevent the dinghies from leaving the track. Also by covering the track instead of the roofless track, it can prevent dinghies crashing, although it will lower the excitement. In RCT1, covered track sections also cost $1 more than uncovered ones.
Place covered sections where boats experience negative gs. Any section experiencing a negative g of above 1.0g will cause the boat to fly off the track. Potential trouble spots include
Crests of hills. When the slide slopes up and then levels, put covered sections!
Transitions from gentle (20o) to steep (60o) slopes when going downwards.
Transitions from steep (60o) to gentle (20o) slopes when going upwards.
Start of downwards slopes. When the slope transitions from level to gentle slopes, dingies will crash if travelling at a high enough speed.
If entering a downward slope with too much side friction (directly after a turn), the boats will leave the track as well unless covered.
Note that the dinghies are heavier when carrying guests, so the test mode can be deceptive.
N.B lift hills are never covered. So place your lift hills only at the very top of a hill, i.e when you are sure the boats aren't going fast enough to crash, but not so high up such that dinghies can't climb to the lift hill.
Water slides have considerable friction, so dingies are notorious for stopping in the middle of a level section and causing a traffic jam as the boats pile up behind the stalled boats. This most often happens after a safety cut out, when the lift hill stops working. When that happens, doubleclick "close" on the traffic lights to clear the track, then reopen it.
This ride is called Dinghy Slide in RCT2 and Dingy Slide in RCT3
In the RCT2 readme, a message says that the water slide does not include water, even though it is located under water rides.
To prevent this ride from stalling out, you should have only 1 lift hill (right out of the station). Make sure that the boat can make the course, WITHOUT creating another lift.
If you are not good at creating a water slide, you can simply use the Demon Drop (ride name) in RCT 1 and 2.
Remember, with a bit of practice in building them, water slides can be popular rides!
The Amazing Earl/Dan Wolfe created a downloadable Water Slide where the guests put on their swimsuits and slide down the slippery slopes. Instead of dinghies, the guests slide down the ride on their stomaches. However, this ride works just like the original dinghy slide, except that you can't see the inflatable boats.
A close up of what the guests look like riding the Water Slide.
